«
»

IH37 Disk Progress…sortof

By yazallcrop

I now have a free download of the dealers parts catalog.

Also, I have put up a page of the first few aftermarket parts for the disk I now can get.  Will add more as I go forward.

I will not really get into the meat of this restore till after fall harvest as this is the busy time of the yeard for the All-Crop business

This entry was posted on June 25, 2009 at 6:33 pm and is filed under International Harvester 37 Wheel Disc. You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response, or trackback from your own site.

4 Responses to “IH37 Disk Progress…sortof”

  1. Rawleigh Says:
    June 30, 2009 at 7:22 pm | Reply

    Tom: Here is a good cheap source of disc bearings. I got flange bearings from them this Spring for my Burch disc.

    http://www.thebigbearingstore.com/discharrowbearing.html

  2. Tom Yaz Says:
    July 1, 2009 at 12:40 am | Reply

    Hi Rawleigh,

    I will check them out. Thanks for the tip!

    Tom

  3. Steve Wilke Says:
    August 11, 2009 at 7:44 am | Reply

    Hello, I have an International 37 model disk 9′ 7″ wide. I am having trouble pulling it with my current tractor. What size vintage tractor do you recomend to pull it? Does anyone know the minimum draw bar horsepower required to pull it? Please help as I want to purchase a different tractor but don’t want one that is to large and over kill. Thanks Steve

  4. Tom Yaz Says:
    August 11, 2009 at 3:26 pm | Reply

    Hi Steve,

    I would give yourself 50 HP min to pull it. I am using a Allis D17, which is in the 50 range.

Leave a Reply